Yakima LANDING PAD 22 Manual De Instrucciones página 3

3
PREPARE THREADS.
Be sure the threads are clear of paint by
carefully threading your fastener in and
out of the hole a few times while blowing
away any debris that accumulates.
NOTE: If there are multiple
holes in the front pocket,
use the forward-most holes.
Use the rear-most in the rear
pockets to gain maximum
crossbar spread.
5
ATTACH LANDING PADS USING YOUR VEHICLES SPECIFIC HARDWARE (IDENTIFIED ON PAGE 2).
A. Place Landing Pad over each roof pocket making sure arrows face the direction specific
to your vehicle.
B. Install the metal washer on each bolt with the concave side facing up.
C. Using the 5mm hex wrench, guide fastener with washer through Landing Pad, and into the
BE SURE TO USE
threaded mounting point in the roof.
THE CORRECT
D. Jostle and rotate Landing Pad in all directions to ensure it is snug, but also allows a small
PADS AND
amount of adjustment to prepare for final alignment and tightening in step 6.
HARDWARE TO
Repeat for all Landing Pads.
AVOID VEHICLE
DAMAGE!
A
INSTRUCTION #1035907B-3/12
NOTE: Some vehicles have
a plug in the threads which
must be removed.
B
Concave side up.
4
INSTALL PADS TO BASES.
Attach each pad to each base.
4X
C
NOTE: Final tightening will happen in the next step.
4X
WARNING: DO NOT ALLOW
EDGES OF PAD TO CURL UNDER!
D
4X