Maintenance And Cleaning - Sammic PCS Manual De Usuario

Bascula electronica
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
This message indicates that the total was exceeded when the multiplication price per weight exceed
999999 then appear lines in the "TOTAL" indicator.
If this message appears in the display, indicates that the scale needs to be recharged. Even with this
advise the scale can continue working during a time of 30 min. If this appears and after some
seconds the scale turns off , this indicates that the scale is completely discharged. In this point the
scale doesn't work and all of the operations performed at that time will be lost. To correct this
problem connect the AC/DC adaptor for a period of time of 10 hrs. and keeping the scale off. In case
of using the scale during this period, there's no problem to use it, only the recharge time will be
higher.
This arrow indicates that the scale is working under the "FIXED PRICE" mode.
This arrow indicates that the scale AC adaptor is connected to the 220 VCA
-- Do not use a flow of water to clean your scale. Use a damp rag and clean each of these
components daily: plate, cover, keyboard.
-- To remove oil and greasy substances, use a dry and clean rag, rubbing the dirty area several
times.
-- Periodically check the jack (where the AC/DC power supply is inserted) to make sure it is in good
condition, there are no signs of strokes or detachments.
-- Periodically check the AC/DC power supply to make sure the ends are in good condition and the
cable is not twisted or tangled.
-- Regularly check the scale to assuring it of it´s correctly leveled with its four bases well supported.
-- When you clean the scale make sure there are not any papers, or any other kind of material
under the plate or under the plate-holder that could obstruct the adequate operation of your
scale.
-- Periodically place some type of insecticide on the scales base to avoid insects (especially roaches)
that can dirty the interior and alter its adequate operation.
-- Do not use detergents nor corrosive liquids while cleaning.
-- Do not expose your scale to temperatures below -10 ºC (14 ºF) or above 40 ºC (104 ºF).
14
ENGLISH

MAINTENANCE AND CLEANING

Publicidad

Tabla de contenido
loading

Tabla de contenido