SKYLOTEC ALUFIX Instrucciones De Uso página 18

5.1 Installation instructions for anchor point Skylotec Alufix AP-003 and AP-
US-003 with Würth Screw Anchor W-SA A4 12x100
1
2
3
4
MAT-MA-0038-EN ALUFIX
Pay attention to fixing installation instructions and
approval (ETA-06/0277).
Make a bore hole with a drill nominal diameter of d
h1 ≥ 100 mm vertically to the anchor base surface using a hammer drill.
Remove the bore dust, e.g. by blowing it out
Insert the screw anchor in the anchor base through the anchor point's
2 through-holes.
Manually, or using a tangential impact wrench, secure the screw
anchor until the anchor point's base plate is pressed against the
concrete base. Recommended torque: 55 Nm.
04/07/2017
=10 mm and depth of
o
Page 5 of 12