MRA XLV 600 TRANSALP Instrucciones De Montaje página 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA screen
2 Rivets short
1 Edge Protection strip and clamp sleeves
Fitting the screen to the motorcycle:
1. Place the motorcycle on a flat surface.
2. Mount the screen the same way as the original screen was mounted.
3. Then drill the two additional holes of diameter 5.1 - 5.2 mm through the
screen into the panel.
4. Insert each of the plastic expanding pins included through the holes, break
off the pin, turn and push in until flush.
5. If included in the scope of delivery: apply the edge guard profile to the
exposed rear area of the windshield, starting at the fairing transition and
ending at the opposite side. Cut off the rest if required.
6. It is also possible to push the clamping sleeves over the ends of the
protective edge strip and lightly compress these using a pair of pliers to
secure the edge strip.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
Honda XLV600 -1993
Article No..
---
10677
---
3
Required tools