Cleaning And Maintenance; Technical Specifications - HQ-Power VDPLW1601 Manual Del Usuario

b) Stand alone mode (master)
• DIP switches 9 and 10 must be set to OFF, the other switches set the light effect (see table below).
DIP effect
switch
1 red LEDs on
2 green LEDs on
3 blue LEDs on
4 white LEDs on
5 colour changing
6 gradual colour changing
7 flash colour changing
8 flash colour fixed

7. Cleaning and maintenance

• All screws should be tight and free of corrosion.
• The housing, the lenses, the mounting supports and the installation location (e.g. ceiling, suspension,
trussing) should not be deformed, modified or tampered with e.g. do not drill extra holes in mounting
supports, do not change the location of the connections ...
• Mechanically moving parts must not show any signs of wear and tear.
• The electric power supply cables must not show any damage. Have a qualified technician maintain the
device.
• Disconnect the device from the mains prior to maintenance activities.
• Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.
• There are no user-serviceable parts.
• Contact your dealer for spare parts if necessary.

8. Technical specifications

Use this device with original accessories only. Velleman nv cannot be held responsible in the
event of damage or injury resulted from (incorrect) use of this device. For more info
concerning this product and the latest version of this user manual, please visit our website
www.hqpower.eu. The information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved.
No part of this manual or may be copied, reproduced, translated or reduced to any electronic medium or
otherwise without the prior written consent of the copyright holder.
07.09.2010
remarks
use the UP [1] and DOWN [4] button to set the brightness
DIP switches 1, 2, 3, 4: set changing speed (all OFF = fast)*
DIP switches 1, 2, 3, 4, 5: set changing speed (all OFF = fast)*
DIP switches 1, 2: set flash frequency
DIP switches 3, 4, 5, 6: set colour changing speed*
DIP switches 1, 2, 3, 4: set colour
DIP switches 5, 6, 7: set flash frequency*
* the UP [1] and DOWN [4] button can also be used to change the speed
power supply
power consumption
DMX channels
number of LEDs
dimensions
weight
VDPLW1601
230VAC / 50Hz
25W
6
16 pcs (each colour 4 pcs)
215 x 70 x 78mm
730g
6
©Velleman nv