Publicidad
OPEN
CLOSE
4
English
TO ADJUST PEAK ANGLE
Slightly loosen all screws of the peak with a coin or flat blade screwdriver
so that the peak can be moved up and down without scratching helmet
surface. Put the helmet on and adjust the peak to the desired position.
Tighten the screws and take helmet off. Tighten all screws firmly but do
not over-tighten.
TO ADJUST LOWER FACE COVER
Slightly loosen all screws of the lower face cover with a coin or flat blade
screwdriver so that the cover can be moved up and down. Adjust the
cover to the desired position, and tighten all screws firmly but do not
over-tighten.
WARNING: The lower face cover does not protect against impacts. The
lower face cover is intended as a rock guard. The lower face cover is
not covered by helmet standards.
TO OPERATE TOP VENTS
Simply push/slide the switch/lever on each duct to open/close the ducts
as illustrated.
WARNING: Never attempt to adjust ventilation ducts when in motion
riding your motorcycle.
Publicidad
Capítulos
