Install The Trigger Handle; Install The Rear Blower Tube; Install The Front Blower Tube; Install The Battery Pack - GreenWorks Pro BLB484 Manual Del Operador

WARNING
• If the parts have damage, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the service
center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with local
regulations.
10.2

INSTALL THE TRIGGER HANDLE

1. Move the trigger handle (10) onto the rear blower tube
(6).
6
2. Move the trigger handle to necessary location on the rear
blower tube.
3. Install and tighten the available short screw.
10.3 INSTALL THE REAR BLOWER
TUBE
1. Put the hose clamp (5) around the flexible tube.
2. Put the end of the rear blower tube (6) into the flexible
tube at a small angle.
English
10
7
6
5
3. Push the end of the rear blower tube into the flexible tube.
4. Install and tighten the available long screw into the hose
clamp.
WARNING
Put the cord in the cord retainer.
10.4 INSTALL THE FRONT BLOWER
TUBE
1. Align the grooves on the front blower tube (4) with the
tabs on the rear blower tube.
2. Install the front blower tube onto the rear blower tube
until the tabs engage the grooves.
3. Turn the front blower tube in the direction of the arrow
until the tabs lock into position.
4
10.5

INSTALL THE BATTERY PACK

WARNING
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read, know, and do the instructions in the battery and
charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
EN
11