Product Cleaning; Culla Primonido Car Kit; Serial Numbers - Peg-Perego culla primonido Instrucciones De Uso

adjust the backrest to its lowest position (figure 8).
GANCIOMATIC SYSTEM
11 The Ganciomatic System enables you to fasten the bassinet
quickly and easily, with one simple operation, to the
Ganciomatic base of the Bassinet Stand and the Classic
Chassis (purchased separately).
To attach the pram, put it on the chassis and press with
both hands until it clicks into place.
Always apply the brakes on the chassis before attaching
and removing the pram.
IMPORTANT: Check that the pram is properly attached.
12 To release it, press the lever under the bassinet and lift it.
13 REMOVING THE LINING: To remove the lining of the hood,
unfasten the 6 buttons on the lower profile.
14 Press the buttons on the two fasteners and remove the
hood.
15 Pull out the flap of fabric under the handle of the hood and
pull out the two rigid supports.
16 Raise the backrest (fig_a) to make it easier to remove the
mattress (fig_b).
17 Unfasten the 6 buttons on the outside of the bassinet and
remove the inner lining.
18 Finally, unfasten the 10 elastic bands on the bottom of
the bassinet and the other 4 positioned close to the hood
fasteners, and remove the outer lining.
19 To replace the lining of the bassinet, do the opposite. While
replacing the outer lining, make sure to slip the outer rings
into the right slots.
20 When placing the lining on the hood, ensure you insert the
rigid supports correctly. Insert the tube bearing the carry
handle into the hood's front slot, ensuring the handle is
centered correctly (fig_a). Pull the flap of fabric out from
the opening on the hood (fig_b) and slide it under the
handle (fig_c).
21 Finally, slip the second metal support into the hood's inner
slot.
22 Fasten the hood to the appropriate supports and fasten
the 6 buttons.
Padding cleaning instructions
Brush the fabric parts to remove dust.
• When washing, closely follow the instructions stated on
the label sewn into the cover.
• Do not use chlorine bleach.
• Do not iron.
• Do not dry clean.
• Do not remove stains with solvents and do not tumble dry.

Product cleaning

• This product requires a small amount of maintenance.
Cleaning and maintenance must only be carried out by adults.
• Keep all moving parts clean and if necessary lubricate
them with light oil.
• Clean the plastic parts periodically with a damp cloth. Do
not use solvents or similar substances.
• Brush the fabric parts to remove dust.
• Do not clean the polystyrene shock absorbing device with
solvents or other similar products.
• Protect the product from atmospheric agents: humidity,
rain or snow. Extended exposure to sunshine can cause
colour changes in many materials.
• Store the product in a dry environment.
• Remember to regularly ventilate the interior of the carrycot.

Culla Primonido car kit

• Culla Primonido can be installed in your vehicle by
purchasing the Culla Primonido Car Kit.
• Only the Culla Primonido Car Kit should be used to fasten
to Culla Primonido to your vehicle securely.
The Original Accessory Peg-Pérego
Peg-Pérego accessories are designed as a useful, practical
means of simplifying the lives of parents. Discover all your
product's accessories on www.pegperego.com.

Serial numbers

23 Information about the production date of Culla Primonido
can be found under the base.
• Product name, production date and serial number.
This information is required for any complaints.
15