Vacuuming Dry Materials; Vacuuming Liquids; Emptying The Drum - Craftsman CMXEVBE176060 Manual De Instrucciones

Vacuuming Dry Materials

1. The Filter must always be in correct position to reduce
the risk of leaks and possible damage to Vac.
2. When using your Vac to pick up very fine dust, it will
be necessary for you to empty the Vac Drum and clean
the Filter at more frequent intervals to maintain peak
Vac performance. Quick Lock™ Filter plus a Filter
Bag is recommended for improved Fine Dust Vac
performance.
NOTE: A dry Filter is necessary to pick up dry material.
If you use your Vac to pick up dust when the Filter is wet,
the Filter will clog quickly and be very difficult to clean.

Vacuuming Liquids

WARNING:
!
Do not operate without filter cage and float,
as they prevent liquid from entering the impeller and
damaging the motor. For dry material pick-up, do not
operate without the filter in place to reduce the risk of
damage to the motor.
WARNING:
!
To reduce the risk of fire or explosion, do not vacuum
flammable or combustible liquids, gases or dust.
1. When picking up small amounts of liquid the Filter
may be left in place.
2. When picking up large amounts of liquid we
recommend that the Filter be removed. If the Filter
is not removed, it will become saturated and misting
may appear in the exhaust.
3. After using the Vac to pick up liquids, the Filter must
be dried to reduce the risk of possible mildew and
damage to the Filter.
4. When the liquid in the Drum reaches a predetermined
level, the Float mechanism will rise automatically
to cut off air-flow. When this happens, turn off the
Vac, unplug the Power Cord, and empty the Drum.
You will know that the Float has risen because Vac airflow
ceases and the Motor noise will become higher in
pitch, due to increased Motor Speed.
IMPORTANT: To reduce the risk of damage to the Vac
do not run Motor with Float in raised position.
SP7092-1 12 & 16 GALLON.indb 11
Emptying the Drum (Fig. P)
1. Remove the Powerhead Assembly. Pull Latches to
release from the Drum.
2. Lift the Powerhead Assembly up and away from the
Drum.
3. Lay Powerhead Assembly upside down on a clean area
while emptying the Drum.
4. Dump the Drum contents into the proper waste
disposal container.
5. The Vac comes equipped with a Drain, simply
unscrew the Drain Cap and lift the opposite side
slightly to empty the Drum.
WARNING:
!
To reduce the risk of back injury or falls,
do not lift a Vac heavy with liquid or debris. Scoop
or drain enough contents out to make the Vac light
enough to lift comfortably.
Fig. P
Drum
Latches (2)
Drain
11
9/13/19 9:07 AM