Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
EN-8
9 Pin connector
Position rib
5. Disassemble the cable gland by loosening the cap nut and removing the rubber seal. Pass
the Ethernet cable through the cap nut; then spread the rubber seal and place it over the cable.
Now pass the cable through the body of the cable gland.
Ethernet cable
M25 cable gland
Cap nut
6. Put the rear housing back on the front housing. Re-install the 6 screws (Torque is
1.8N*m± 0.5). Insert the Ethernet cable through M25 hole. (Note: the direction which is the hook
of the Ethernet plug face down).
Ethernet cable
7. Fasten the M25 gland to the rear housing.
Publicidad
Tabla de contenido
