OHAUS Ethernet Manual De Instrucciones página 7

5. Disassemble the cable gland by loosening the cap nut and removing the rubber seal. Pass
the Ethernet cable through the cap nut; then spread the rubber seal and place it over the
cable. Now pass the cable through the body of the cable gland.
6. Put the rear housing back on the front housing. Install the 6 sealing screws (Torque is
1.8N*m± 0.5). Insert the Ethernet cable through the housing and connect it to the Ethernet
board.
M25 Hole
7. Install the body of the cable gland into the rear housing. Tighten the cable gland.
8. Push the rubber seal into the body of the cable gland.
Cap nut
Rubber seal
Ethernet cable
M25 Cable gland
Cable gland
EN-5