Samsung NX58 Serie Manual Del Usuario página 40

Maintenance
How to run a self-cleaning cycle
Make sure the door lock is released. Remove all racks from the oven cavity.
02
Make sure the oven door is unlocked and closed completely.
1.
2. Press the Self Clean pad once. Then, select the cleaning time by pressing the
Self Clean pad one or more times in accordance with the table below.
Once
3 hour
3. Press the START/SET pad. The oven door is locked and the oven begins to heat
up.
When the cycle is complete, the oven beeps 6 times. The door will remain
4.
locked and the Lock icon will blink until the oven temperature falls below
400 °F (204 °C).
5. When the Lock icon changes to an open lock, you can open the oven door. The
Lock icon changes to an open lock when the oven temperature drops below
400 °F (204 °C).
6. Press the OVEN OFF pad to display the time of day.
CAUTION
Do not use the surface burners while the gas oven is performing a self-cleaning
cycle.
WARNING
Be sure all controls are OFF and all surfaces are COOL before cleaning any part of
the range.
NOTE
Make sure all surface burners are off while the oven is performing a self cleaning
cycle. Self-clean will not operate if a surface burner is on.
40 English
NX5000M_NX58M6650WS_AA_DG68-00993A-04_EN+MES+CFR.indb 40
03
Twice Three times
5 hour 2 hour
To delay starting the self-cleaning cycle
1. Repeat steps 1 and 2 on the previous page.
2. Press the Delay Start pad. The oven door locks.
3. Set the time you want the oven to start self-cleaning using the number pad.
Press the START/SET pad. The oven will start self-cleaning at your specified
4.
time.
To cancel the self-cleaning cycle
You may find it necessary to stop or interrupt a self-cleaning cycle due to smoke
in the oven. To turn off the self-cleaning cycle, press the OVEN OFF pad. The cycle
turns off, but the door remains locked and the Lock icon blinks until the oven
temperature falls below 400 °F (204 °C).
After self-cleaning
• The door stays locked until the internal oven temperature falls below 400 °F.
• When the oven has cooled down, wipe the oven surfaces with a cloth to remove
ash residue.
• Stubborn stains can be removed using a steel-wool pad. Lime deposits can be
removed using a vinegar-soaking cloth.
• If you are not satisfied with the cleaning results, repeat the cycle. "HOT" appears
on the display until the oven cools down. Wait until the message disappears, and
then start a new cycle.
• The cooling fan automatically runs for certain amount of time after self-cleaning.
Self-cleaning does not operate within 2 hours after running the self-cleaning cycle.
•
CAUTION
Do not attempt to open the oven door immediately after the self-cleaning cycle is
complete. The oven is still very hot when the door unlocks. Escaping hot air and/or
steam could burn you.
03 04
02
2018-12-18 6:57:25