Publicidad
Idiomas disponibles
Idiomas disponibles
BV 3500
How to assemble and use
Important: Your blender jar and cutting blades are subject to wear during normal use. Always inspect
cutting blades for broken, cracked or loose blades. If jar-cutting blades are damaged, do not use.
1. Make sure blender is unplugged. Place blender base on clean, dry surface.
2. Place the jar on the motor unit. Insert the jar on the body by fitting in the
triangles printed in both places. Important: this blender is fitted with a
safety device that stops the motor from starting if the jar is not positioned
correctly. The blade assembly must be screwed into the jar firmly. If not, it
may loosen when the motor is turned on.
3. Peeled or cored the fruit or vegetables and then cut it into small dices, put
the food piece into the jar. Usually certain amount of purified water has to
be add to facilitate the smooth running of appliance. The amount of mixture
should not exceed the max level as indicated on the jar. Process food or
beverages. Place hand on lid when blending liquids. Push button on control
panel to start blender. Note: never use boiling liquid or run the appliance
empty.
4. Replace the jar cover on the jar.
5. You may add ingredient into the jar through the center opening of jar cover during operation,
then close the measuring cup if necessary. Note: the measuring cup can only be opened by
pressing the end with the mark of push, but never remove out.
6. Connect the plug to wall outlet and set speed control to your desired setting. You can turn the
speed control to the P position if want to accelerate the process of blending. The detailed
information of speed control. The motor can work continuously for 2 minutes. After that it have
to be off for 5 minutes.
7. Turn the speed control to 0 position once the mixture has been blended to your desired
consistency.
8. Remove the jar from the motor unit, carefully take down the jar covert, then pour and serve.
9. If you have to stir in food that us tuck to the sides of the jug, then switch the appliance off first.
The blades may continue to rotate for a moment longer. Keep spoons or spatulas a good distance
away from the blades to avoid accidents. Always turn blender OFF and wait until blades have
stopped rotating before removing jar.
10. Never place jar onto unit while motor is running.
SPEED
Speeds are 1, 2 and P. P is a controlled cycle operation. This means it operates only while the button is
held down. All other speeds are continuous cycle operate continuously at whatever speed is selected until
turn the knob to the right.
For continuous operation
Rest one hand on top the blender jar with lid securely in place. Rotate knob to desire speed setting to turn
blender on.
11
Publicidad
