Orbegozo BV 3500 Manual De Instrucciones página 12

BV 3500
For controlled cycle operation
Rest one hand on top of blender jar with lid securely in place. Press P button and hold down for about 2
seconds. Release button and allow blades to coast to a stop. Repeat cycles until ingredients reach desired
consistency. Release of the P button turns blender off. Note: P button can be held longer than 2 seconds
as needed.
HINTS FOR BEST USE
•
To add foods when blender is operating, remove filler-cap from jar cover and add ingredients
through the opening.
•
If using your blender to make salsa or other recipes using tomatoes, onions and/or other
vegetables, you may have better results using a slower speed function.
•
If blending action stops during blending or ingredients stick to the sides of the jar, turn blender
OFF. Remove the cover and use a rubber spatula to push mixture towards blades.
•
Do not store food or liquids in the blender jar.
•
Avoid bumping or dropping the blender.
•
Do not use the blender to store food.
•
Do not use the blender to bear egg whites as it will not incorporate air.
•
Do not use the blender to mash potatoes.
•
Do not use the blender to knead dough or other heavy mixtures.
•
Do not place large pieces of solid of frozen foods into the blender jug. Always break pieces before
blending.
•
Do not process boiling liquids or hot ingredients. Allow hot ingredients to cool before placing
them into the blender jug.
HOW TO CLEAN THE BLENDER
1. Unplug the blender from electrical outlet.
2. Remove the jar from the blender base. Remove the lid, add a cup of cleaning solution made by
adding a few drops of dishwashing detergent to 1 cup of cool water to the lid. Scrub and flush out
the interior of jar and the lid to dislodge and remove as much residue as possible. Empty the jar.
3. Add more cleaning solution, put lid on jar, place in on motor base, and run on high speed for two
minutes.
4. Empty the lid and repeat as above using clean rinse water in place of cleaning solution. Empty,
rinse and dry prior to storing unit.
5. Wipe blender base, control panel and cord with a damp cloth or sponge. To remove stubborn
spots, use a mild, non-abrasive cleaner.
6. Carefully wash the gasket, jar and cover in hot soapy water.
7. In order to clean the blades, turn clockwise the device placed at the bottom of the jar in order to
disassemble them. Rinse and dry thoroughly. Do not wash blades, gasket, plastic jar or cover in
dishwasher.
Note: Do not immerse the motor base, power cord or power plug in water or any other liquid.
12