After Installation - hafele WT 210 Instrucciones De Montaje

6.3 After installation

5. Push the reader into the frame until it has engaged into the retaining rails at both
sides.
Fig. 12: WT 210 / WT 210 BLE with frame
1. Re-establish the voltage supply.
2. Check function.
The installation was performed correctly, if the following
is true:
• LED illuminates red.
Configuration and start-up
The system configuration and the configuration of the
WT 210 / WT 210 BLE take place via the software, and are
carried out by the system supplier's authorised customer
service.
The initial start-up of the access control system is also carried
out by the system supplier's customer service.
To ensure that the current Dialock firmware is running on the
terminal, the device has to be flashed (programmed) using the
mobile programming unit (MDU) during start-up.
In case of questions concerning the firmware version or the
procedure please contact Häfele.
BLE = Bluetooth Low Energy
Products that are equipped with BLE can also be operated
via smartphone (Android/IOS) with a suitable app. In case of
questions concerning smartphone applications please contact
Häfele.
More information about the start-up and configuration of the
overall system can be found in the Dialock 2.0 user manual.
39