Cleaning And Maintenance - KTM Power Parts TOP-CASE 46 Instrucciones De Montaje

8
7
9
4
1
A
5
6
Be sure to read the following information before you use your topcase.
A mounted topcase, especially when loaded, can affect vehicle handling
due to strong crosswind sensitivity as well as its cornering ability and bra-
king performance.
Drive carefully in strong winds.
Because of the difference in the vehicle handling, slowly approach the
recommended maximum speed of 130 kph.
Secure the load to prevent it from moving around.
Be sure not to exceed the maximum load of 6 kg.
Do not drive faster than 130 kph with the topcase mounted.
Make sure all latches are locked during the ride.
Do not use a topcase that has been damaged in any way.

CLEANING AND MAINTENANCE:

To clean your topcase, use a soap solution (around 50°) and a soft cloth
or sponge. Rinse with clear water and allow to dry. Afterwards, spray the
inside and outside (incl. all fittings and latches) with silicone spray and
wipe off with a dry cloth. Do not leave the topcase open when not in use
since this can affect its waterproof capacity.
Caution: Do not use organic solvents such as gasoline or thinner.
Scope of supply:
1 pc. Topcase 46
1 pc. Item 1 Lower adapter plate
(4 pcs. Item 2 )*
(4 pcs. Item 3 M6x30) *
4 pcs. Item 4 Ø6 ESP disk
4 pcs. Item 5 Ø6 Washer
4 pcs. Item 6 M6 Nut
1 pc. Item 7 Upper adapter plate
3 pcs. Item 8 M5x12 Screw
4 pcs. Item 9 M6x20 Screw
* not used
Not included in the scope of supply:
Base plate [A] for mounting the adapter plate [1] for the respective
model. This information is available from your KTM dealer (Dealernet).
Accessories: page 5
Position the TOPCASE adapter plate [1] at the mounting points and
mount with the screws [9], the special disks [4], the washers [5] and
the nuts [6]. Tighten, insert the lid [7] in the corresponding fixtures
and attach with the screws [8].
3