dirna Bergstrom bycool DINAMIC 1.1 Instrucciones De Montaje página 21

DINAMIC 1.1
Position the bushing and nut covers.
6
6
Use bushing to pass the wastewater pipe
7
through the Ø19 borehole to the inside of the
cabin.
On the studs, screw on (4) M6 nuts with (4)
8
Ø6 flat washers, which should be level with the
cover.
SEE ATTACHED DIAGRAM
VERY IMPORTANT
!
In the case of slanting upholstery, the evaporator
unit must be vertical or sloping from the lower
section to the outside in order to prevent the
condensation water from dripping onto the
upholstery.
Upholstery
Evaporator
bracket
Wastewater
tray
Wastewater
pipe
6
7
Lorry sheet
OUTSIDE
M6 self-blocking
nut
Protector cap
M6 Stud
Wide ring flat
washer
Rubber washer
21
Upholstery
INSIDE
Evaporator M6 Nut
base (leave at
M6 Nut upholstery height)
M6 Nut
Wide ring
Wide ring
flat washer
flat washer
EN
®
8