Adding Salt - Innowater SMC Serie Manual Del Usuario

The water must be clean and clear, presenting the following parameters:
Salt
pH
TAC
TH
Stabilizer
Temperature

5. ADDING SALT

The chlorinator must remain totally disconnected during this operation
and until the salt is completely dissolved. Operating the chlorinator
with non dissolved salt could irreversibly damage the cell and the
power supply, and lead to a cancellation of the warranty.
Calculate the volume of the swimming pool and add 5 to 6 Kg of salt per cubic meter.
Make sure the chlorinator is disconnected and make the filtration system to work for at
least 24 hours.
If you have a cement pool just built, let it cure for at least four weeks
before adding salt.
The salt dissolving process can be accelerated using the pool cleaner. Check the salt
concentration is between 5 and 6 kg/m
The salt chlorination process don't consume salt. However, the salt concentration may
be reduced over time due to the rain or other periodic freshwater contributions (filling
up, filter cleaning, etc.). Whenever the salt concentration needs to be corrected, pour
salt as close as possible to the return lines. Never pour salt in the skimmers or in the
drain inlet.
SMC
3
5-6 kg/m (gr/l)
7,2-7,6 (cement) 6,8-7,0 (polyester)
60-100 ppm
15-20º French
20-30 ppm (or according to the indications
by the manufacturer)
>10 º C
3
using a kit from a specialized pool shop.
22