Innowater SMC Serie Manual Del Usuario página 24

Shock
Select duration
SHOCK
Remaining: 07:00
Cancel Shock?
YES:OK NO:MENU
1 Language setting
From the Production Screen press MENU. The following screen will appear:
MAIN MENU
1 Language
Choose language
English
2 Polarity period setting
The polarity applied to the cell is periodically reversed to remove calcium built-up. The
factory pre-programmed period is 8 hours. Depending on the conditions of your pool it
may be necessary to reduce this period in order to increase the frequency of cleaning.
Note that the shorter the period, the shorter the cell life span. A period of less
than 4 hours will drastically reduce the life of the cell. Inversely, you should increase
this period if your cell don't need to be cleaned that frequently. We recommend, in
general, to set this period to the larger number of hours as long as there is not calcium
build-up on the electrodes.
To change the polarity period, go to the Production Screen and press MENU. The
following screen will appear:
MAIN MENU
1 Language
SMC
Select a number of hours, by using the
7 h
and press OK to accept or MENU to exit. If you click
OK, you will enter into the Shock mode and the
following screen will be displayed:
If you want to quit the Shock mode press any key. The
7 h
following screen will be displayed:
Press OK to exit the shock mode or MENU to continue
the shock treatment.
Press OK to enter the Language menu.
Choose a language using he arrows Λ V and confirm by
pressing OK. Press MENU to return back to the
production screen.
Press the
Polarity period as shown in the following screen:
Λ V
or buttons until you reach the menu 2
24
Λ V
or arrows