Operation - Dexter 20VSD2-35RC.1A Manual De Instrucciones

9. OPERATION

. Push battery pack into the bottom of the handle ( until click )
. Remove the battery pack by pressing the release button on the battery pack and by pulling the
battery pack out.
1
1
Inserting drill bits / screwdriver bits
. Hold the back section of the chuck and rotate the front section of the chuck(Release direction)
. Insert the drill bit / screwdriver bit into the chuck.
. Tighten the chuck by hand(Hold the back section of the chuck and rotate the front section of the
chuck(Grip direction)) and check if the drill bit/ screwdriver bit holder is firmly in the chuck.
. Select the correct screwdriver bit to avoid damaging the screw when screwing function.
1. Chuck
2. Torque adjust ring
Note: The chuck is removable.When you remove the chuck, you can directly insert the hexagonal
bit into the output shaft.
2
1
1
3
2
3
1. Cordless drill
2. Battery pack
3. Release button
2
2
FR FR
ES ES
PT PT
IT IT
EL EL
PL PL
RU RU
UA KZ
KZ UA
RO RO
BR BR
EN
EN
251