Dexter 20VSD2-35RC.1A Manual De Instrucciones página 252

FR FR
1
9. OPERATION
ES ES
PT PT
. To switch on the tool, press the on/off switch
IT IT
. To switch off the tool, release the on/off switch
EL EL
PL PL
Set the Left/right switch to
RU RU
. Change the direction of rotation only when the machine is not in operation !
UA KZ
Caution
. Operating the machine with a low speed for a long time will increase the risk that the motor
KZ UA
will be overheated. To prevent overheating, let the motor cool down regularly ( Stop using the
machine for 15 minutes )
RO RO
CAUTION: Please support and clamp the workpiece properly. Do not use hand to grip or
clamp the workpiece, it may cause injury.
BR BR
EN
EN
. Torque setting 1 to 5 ---> low speed
. Torque setting 6 ---> high speed
The tool has an LED light to illuminate the work area and improve vision when working in areas
with insufficient light.
The LED light will switch on automatically while the trigger switch is depressed.
. The torque setting will help you regulate the driving power when using a screwdriver bit. This will
help to prevent damage to the workpiece
. and/or screw.
. For drilling set the torque selector to the position indicated by the drill bit symbol.
. Advice: Always start with the lowest torque setting and increase If necessary.
252
1
2
2
1
Left/right switch
shown on the left/right switch
1
On/off switch
1
Set the Left/right switch to
Variable speed
LED worklight
Torque setting
2
1
2