Mounting Instructions - Pahlen 300A Manual De Instrucciones

LED light type 300 Marine
Type 300A - for concrete pools

Mounting instructions:

NOTE! Minimum distance between stainless steel material and non-stainless (e.g. Concrete-reinforcing bars) will be 50 mm.
The front edge of the niche shall be in line with the concrete wall (see A in sketch below).
1. Attach and secure the niche to the pool frame with the cable outlet pointing upwards.
2. Apply some water-resistant grease in the threads of the niche.
3. Thread the cable conduit in the niche and in the junction box. The thread shall be sealed with e.g. thread tape.
The cable conduit shall be placed so that the bend radius is not below 100 mm.
4. Place the supplied spacer on the cable of the lamp where it runs through the cable gland of the niche.
Tighten the cable gland in the niche to seal the cable. Insert the cable in the conduit and connect to the junction box.
Wrap excess cable behind the lamp and assemble the lighting unit in the niche.
5. Mount the front ring.
- for concrete pools
Item no 124381: LED white
Item no 124281: LED red/green/blue
Niche
Conduit
Concrete
Tile fix
Concrete
Lamp unit
Sealing ring
Tile fix Tile
10
ENGLISH
Tile
Spacer
Countersunk screw
M5x10 (6x)
Front Marine
Washer (6x)
Screw M5x50 (2x)