Mounting Instructions - Pahlen LED 300C Marine Manual De Instrucciones

LED light type 300 Marine
Type 300A - for concrete pools

Mounting instructions:

The front edge of the niche shall be in line with the concrete wall (see A in sketch below).
1. Fixate the niche. N.B! Cable gland upwards.
2. Apply some water-resistant grease in the threads of the niche.
3. Thread the cable conduit in the niche and in the junction box. The thread shall be sealed with e.g. thread tape.
The cable conduit shall be placed so that the bend radius is not below 100 mm.
4. Place the supplied spacer on the cable of the lamp where it runs through the cable gland of the niche.
Tighten the cable gland in the niche to seal the cable. Insert the cable in the conduit and connect to the junction box.
Wrap excess cable behind the lamp and assemble the lighting unit in the niche.
5. Mount the front ring.
- for concrete pools
Item no 124381: LED white
Item no 124281: LED red/green/blue
Niche
Conduit
Concrete
Tile fix
Concrete
Surface treatment
E
The tolerance class in accordance with this
part of ISO 2768-1
Installationsbild
belysning typ 300A LED
för betongpool
Box 728, SE-194 27 Upplands Väsby, Sweden
Phone +46 8 59411050, Fax +46 8 59086880
Lamp unit
Sealing ring
Tile fix Tile
10
Surface treatment
E
The tolerance class in accordance with this
part of ISO 2768-1
ENGLISH
Tile
Spacer
Countersunk screw M5x10 (6x)
Designed by: Drawn by: Date Approved by:
ASA 2011-12-01
Assembly drawing no. Art.no.
Scale Revised by: Date
TS 2012-03-19
Front Marine
Drawing number Rev.no.
M11605 1
Sid 1(2)
Washer (6x)
Screw M5x50 (2x)
Designed by: Drawn by: Date
ASA 2011-12-01
Assembly drawing no. Art.no.
Scale
Approved by:
Revised by: Date