BERTO'S PLUS 600 Serie Manual De Instrucciones página 57

rust stains due to contamination. For the same
reason, avoid contact with iron objects. Do not use
steel cottons or stainless steel brushes because whilst
they will not contaminate surfaces, they can cause
damaging scratches.
Metal powder, metal shavings from working and iron
material in general, when in contact with stainless steel
surfaces, can cause rust stains. Superficial rust stain might
be present on new appliances and they can be removed
with a detergent diluted in water and a Scotch Brite
sponge. If dirt is tough, do not use sandpaper or rough
paper, but use synthetic sponges (for example Scotchbrite
sponges). Do not use substances for cleaning silver and
be careful with hydrochloric or sulphuric vapours coming
from floor washing products, for example. Do not aim
water jets directly on the appliance, it might be damaged.
After cleaning, rinse properly with clean water and dry
carefully with a cloth.
REPLACEMENT OF THE COMPONENTS
(SPARE PARTS)
Use only original spare parts supplied by the
manufacturer.
All maintenance must be carried out by qualified
personnel. The appliance should be serviced at least
once a year, which is why we recommend subscribing our
maintenance agreement.
LONG PERIODS OF APPLIANCE INACTIVITY
If the appliance is not used for long periods of time, please
observe the following:
WARRANTY CERTIFICATE
COMPANY NAME:
____________________________________________________________________________________________
ADDRESS:
____________________________________________________________________________________________________
POSTAL CODE :
__________
PROVINCE:
_______________
ATTENTION!
The manufacturer declines all responsibility for any inaccuracies in this handbook due to typing or printing errors.
The manufacturer reserves the right to make any changes that may be required without altering the basic features of the
product. The manufacturer declines all responsibility in the event that the instructions given in this handbook are not fully
observed. The manufacturer declines all responsibility for any direct or indirect damage caused by incorrect installation,
tampering, poor maintenance and negligent use.
TOWN:
___________________________________________________________________________
INSTALLATION DATE:
____________________________________________________________
MODEL.
_________________________________________
PART NUMBER:
________________________________
1) Switch off the disconnecting switch to disconnect the
mains
2) Clean the equipment and the surrounding areas
properly
3) Pour a small quantity of cooking oil on the stainless
steel surfaces
4) Carry out all maintenance operations
5) Cover all appliances with a suitable material and leave a
few openings to allow air to circulate.
WHAT TO DO IN THE EVENT OF A FAILURE
In the event of a failure, disconnect the appliance
immediately from the main power supply by means of the
device positioned before the appliance and contact the
Technical Assistance Service.
| 57
EN