Stroller Assembly; Open Stroller; Assemble Front Wheels; Assemble Rear Wheels - Joie juva Manual De Instrucciones

Stroller Assembly

Please read all the instructions in this manual before assembling and using this product.

Open Stroller

2 - 1
Push secondary lock and squeeze one-hand-fold handle
Latches should click into place.
!
Check that the stroller is completely open before continuing.

Assemble Front Wheels

Assemble front wheels to front legs. Check that wheels are securely attached by pulling on wheel assemblies.

Assemble Rear Wheels

Assemble rear wheels to rear legs. Check that wheels are securely attached by pulling on wheel assemblies.
The rear wheels can be disassembled by pressing the snap buttons.

Assemble Hood

To assemble the hood, push hood pivots into the hood mounts.

Secure Footrest

6 - 1
Push the footrest down to secure it.
6
The completely assembled stroller is shown as

Stroller Operation

Adjust Recline
Recline Backrest
7
Pull tab to recline backrest.
!
Hold the backrest with the other hand if a child is already seated in the stroller.
Raise Backrest
Hold both left and right strings and push up the angle adjuster to raise backrest.
! Make sure the backrest angle is set properly for use.

Use Bumper Bar

The bumper bar can be pulled up on both left and right sides.
9 - 1
Press bumper bar release button , and then pull up the bumper bar
with matching component, and then push down to lock.
Tip Bumper bar can be open for easily placing and removing.
13
2 - 2
. Meanwhile, pull the stroller backward.
5
.
8
9 - 2
. Align the bumper bar end

Use Buckle

Release Buckle
Press the center button to release the buckle.
Lock Buckle
Match the waist belt buckle with the shoulder buckle
A click sound means the buckle is locked completely.
! To avoid serious injury from falling or sliding out, always secure your child with harness.
!
Make sure your child is snugly secured. The space between the child and the shoulder harness is about the
thickness of one hand.
3
!
Do not cross the shoulder belts. This will cause pressure on child's neck.
Use Shoulder & Waist Harnesses
4
!
In order to protect your child from falling out, after your child is placed into the seat, check whether the
shoulder and waist harnesses are at proper height and length.
12 - 1
Shoulder harness anchor A
12 - 2
Shoulder harness anchor B
12 - 3
Slide adjuster
For larger child, use shoulder harness anchor A and the highest shoulder slots. For smaller child, use shoulder
harness anchor B and the lowest shoulder slots.
To adjust the position of the shoulder harness anchor, turn the anchor to be level with the short side facing
forward. Thread it through the shoulder harness slot from back to front
is closest to child's shoulder height.
Use slide adjuster to change the harness length.
- 2
Press the button 14

Adjust Calf Support

There are two recline angles, 1-2
To raise calf support, push the calf support from position 1 to position 2
To lower calf support, pull the calf support outward
16
- 2
to position 1.

Use Hood

To open the canopy, pull canopy toward front.
To fold the canopy, pull canopy toward back.
10
11 - 1
, and click into the center buckle.
11 - 3
- 2
13
- 1
14
, while pulling the waist harness to proper length
15
for adjustment.
16 - 1
, meanwhile recline the calf support from position 2
17
17
11 - 2
- 1
13 . Rethread it through the slot that
- 3
14 .
15
.
14