Fan Assembly; Fan Installation - Faro Barcelona HONOLULU Manual De Instrucciones

instrucciones de seguridad / instruction de sécurité / safety instructions / instruções de segurança / sicherheitshinweise / veiligheidsinsturcties /
instruzioni di sicurezza / οδηγίεσ ασφαλείασ / инструкции по технике/ BEZPEČNOSTNÍ POKYNY
NOTE:The important precautions, safeguards and instructions appearing in this manual are not meant to cover all possible
conditions and situations that may occur. It must be understood that common sense, caution and carefulness are factors which
cannot be built into this product. These factors must be supplied by the person(s) installing, caring for and operating the unit.
TOOLS AND MATEIALS REQUIRED
Screw driver.
Blade screw driver.
Wrench or pliers.
Step ladder.
Wire cutter.
Wiring supplies as required by electrical code
UNPACKIING YOUR FAN
Unpack your ceiling fan carefully. Remove all parts and hardware. Place the fan motor on a cloth or soft surface to avoid damaging
the finish.
Do not lay motor housing on its side- the decorative housing may become bent or damage.
Verify that all parts are present before starting assembly
Check the packaging carefully for missing parts- Examine all parts.

FAN ASSEMBLY

1- Insert blade into the blade holder. Starting with the centre hole assemble the bade to the blade holder, insert one of the screws
through a blade going into the blade holder, do not tighten at this point. Repeat for the remaining two holes without tightening.
When all 3 screws have been started and ensuring the blade is straight, tighten all three screws. Repeat for the remaining blades
2- Loosen the three large screws, pass the three screws through the key way holes (the star washers will be between the switch
housing bracket and the light kit. Making sure that no wires are trapped and tighten the three screws
3- Install the light bulb (ensure correct wattage)
4- Using one hand to support the glass shade, place it into the gallery, and carefully rotate the glass shade clockwise. Fit batteries
in hand control unit and check for signal light. Switch the power on and check the operation of your new ceiling fan. If problems
exist check trouble shooting pages.
5- Lift the fan up and place the nylon ball onto the bracket, make sure the guide pin of the bracket fits into the slot of the ball.
6- Install the receiver to the bracket as shown. Connect the wires according to the wiring instruction manual
7- plug intra-red sensor at the canopy into the remote control receiver.

FAN INSTALLATION

33347 Honolulu
faro 10