Electrical Connections; Care And Cleaning - Faro Barcelona HONOLULU Manual De Instrucciones

instrucciones de seguridad / instruction de sécurité / safety instructions / instruções de segurança / sicherheitshinweise / veiligheidsinsturcties /
instruzioni di sicurezza / οδηγίεσ ασφαλείασ / инструкции по технике/ BEZPEČNOSTNÍ POKYNY

ELECTRICAL CONNECTIONS

CARE AND CLEANING

Periodic cleaning of your new ceiling fan is about the only maintenance that is needed. Only use a soft brush or lint free cloth to
avoid scratching the finish. NO NOT use water when cleaning your ceiling fan. It could damage the motor or the wood blades,
and/or create the possibility of electrical shock.
NOTE: periodically it may be necessary to re-tighten blade screws to prevent clicking or humming sound during operation. This is
especially true in climates with broad temperature and humidity ranges and the fans with painted or high gloss blades. When
dusting the blades, you must support the blade to prevent bending no pressure should be applied to the blades.
If you experience any flaws in the operation of your fan, please check the following points:
TROUBLESHOOTING IN CASE OF DIFFICULTY
CAUTION: Switch off the power supply before carrying out any of these checks.
1. If will not start: Check main and branch circuit breakers and/or fuses. Check line wire connections to fan. Make sure
forward/reverse switch is set to one or the other position, not stuck in between
2. If the fan is noisy: Check and make sure that all screws in motor housing are snug (but not over tight). Check that the
screws securing blades to the motor are tight. Check all glassware is finger tight and that bulb are well held in the sockets, if a light
kit is used. Check that the canopy is firmly attached to hanging bracket and not vibrating against ceiling.
3. If fan wobbles: Check all blades are firmly screwed into motor. Check to make sure that light is firmly attached and that all
glassware and shades are fastened properly. Wobble can also result for even the smallest deviations in distance for blade tip to
blade tip, if measurements from blade tip to blade tip are not equal, loosen screws connecting blade to motor one at a time and
adjust blade so that distance are equal. Interchanging adjacent blades may redistribute mass and result in smoother operation.
33347 Honolulu
red
red
faro 11