How To Use The Anti-Balance Kit; Troubleshooting Guide - Faro Barcelona IBIZA Manual De Instrucciones

instrucciones de seguridad / instruction de sécurité / safety instructions / instruções de segurança / sicherheitshinweise / veiligheidsinsturcties /

HOW TO USE THE ANTI-BALANCE KIT

1. Place the balance clip on a blade and turn the fan on and set the speed control setting to a speed in which the wobble is
greatest. MAKE SURE THAT THE CLIP IS FIRMLY PLACED, IF NOT IT MIGHT FLY OFF WHEN THE FAN STARTS TURNING!
2. Repeat this procedure on all blades noting the blade on which the greatest improvement is achieved, because this blade is the
one that is unbalanced.
3. Move the clip inward and outward on this blade and operate the fan to find the position where the clip gives the greatest
improvement.
4. Remove the clip and install a balancing weight to the top of the blade along the centerline near the point where the clip was
positioned.
OPERATION & MAINTENANCE
1. As fans tend to move during operation, some connections may loosen. Check the supporting screws, brackets and blade
attachments twice a year to ensure that they are secure.
2. Cleaning the fan helps to maintain its appearance for years. Do not use water when cleaning. This could damage the motor or
the blades and could cause electrocution.
3. Use a soft brush or lint-free cloth to prevent scratching the surface.
4. There is no need to oil the motor as the bearings are permanently lubricate.
The reversing switch for hot or cold weather depends on factors such as the size of the room, height of the ceiling, number of
ceiling fans, etc. The reversing switch controls the direction of the fan.
Hot weather/downward –The fan will turn in a counter clockwise direction. A downward air circulation creates a cooling. This
allows you to regulate the air conditioner to a higher temperature without affecting your comfort.
Cold weather/upward – The fan will turn in a clockwise direction. An upward air circulation will distribute the warmer air trapped at
the ceiling around the room without causing a draft. This allows you to regulate the heating to a lower temperature without affecting
your comfort.
TROUBLE-SHOOTING GUIDE
The fan does not start:
1. Check the fuses and circuit breakers.
2. Review the connections of the terminal block according to the indications in the installation.
Ensure the power is off before doing this.
3. Make sure that the sliding switch is firmly in the position of up or down. The ventilator does not work when the button is in the
middle.
4. Make sure that the stabilizing tongue-pieces of the motor are off.
5. Finally if the fan will not start call an electrician do not attempt to touch the internal parts.
The fan is noisy:
1. Check that the screws in the motor casing are attached correctly.
2. Check that the screws fastening the blade brackets to the engine block are properly tightened.
3. If using an optional light fitting, ensure the glass is properly fitted and / or the screws holding the glass are firm.
4. If a solid state speed control has been fitted this can cause noises in the motor do not use these control.
5. Allow at least 24 hours for the fan to settle, as many noise will go away. Each blade set is weighed and is a complete set, if
installing more than one fan do not mix the blades as this can cause wobble.
The fan oscillates:
1. Check the blades are securely fastened to the holders.
2. Check the blade holders are tight on the motor
3. Ensure the mounting bracket is properly screws to the ceiling.
4. Interchange opposite blade sets if need be
In general , wobble is caused by the blade not cutting the air at the same point measure down from the ceiling and make sure each
blade is at the same height to the ceiling, if they are not a small adjustment can be made by hand by slightly bending the blade
and bracket. If a major adjustment is needed insert a washer (not provided)
33287, 33288 Ibiza
instruzioni di sicurezza / οδηγίεσ ασφαλείασ / инструкции по технике
faro 12