Purpose Of Use; Technical Specifications - TESY ES/RC GCA 10 Instrucciones De Uso

Dear Clients,
The TESY team would like to congratulate you on your new
purchase. We hope that your new appliance shall bring
more comfort to your home.
This technical description and instructions manual was
prepared in order to acquaint you with the product
and the conditions of proper installation and use. These
instructions were also intended for use by qualified
technicians, who shall perform the initial installation, or
disassembly and repairs in the event of a breakdown.
The observance of the instructions contained herein is
in the interest of the buyer and represents one of the
warranty conditions, outlined in the warranty card.
Please consider that following the current instructions
will primarily be of interest to the consumer, but along
with this, it is also one of the warranty conditions, pointed
out in the warranty card, so that the consumer can
benefit from the free warranty services. The producer is
not responsible for damages in the appliance that have
appeared as a result of operation and/or installation not
corresponding to the instructions here.
The electric water heater complies with the requirements
of EN 60335-1, EN 60335-2-21.

PURPOSE OF USE

I.
The appliance is designed to supply hot water to
household facilities equipped with a piping system
operating with pressure not greater than 6 bars (0,6 Mpa).
It is designed to operate only in closed and heated
premises where the temperature is not lower than 4°C and
it is not designed to operate in a continuous protracted
regime.
II.

TECHNICAL SPECIFICATIONS

1. Nominal volume V, liters - see the appliance's rating
plate
2. Nominal voltage - see the appliance's rating plate
3. Nominal power consumption - see the appliance's
rating plate
4.
Nominal pressure - see the appliance's rating plate
ATTENTION! This is not the water mains pressure. This
is the pressure that is announced for the appliance
and refers to the requirements of the safety standards.
5. Water heater type - closed accumulating water heater,
with thermal insulation
6. Inner coating: GC-glass-ceramics
7. 7. Daily energy consumption – see Annex I
8. 8. Rated load profile - see Annex I
9. 9. Quantity of mixed water at 40°C V40 litres - see Annex I
10. Maximum temperature of the thermostat - see Annex I
11. Default temperature settings - see Annex I
12. Energy efficiency during water heating - see Annex I
English
III. IMPORTANT RULES
•
The water heater must only be mounted in premises
with normal fire resistance.
•
Do not switch on the water heater unless you
established it was filled with water.
•
Qualified W&S specialists must perform the
connecting of the water heater to the water supply
network. Qualified electricians must perform the
connecting of the water heater to the electric network
(for models without power cord with plug). A qualified
technician is a person who has the competence
according the regulations of the country in question.
•
Upon connecting the water heater to the electric
mains care must be taken to connect the safety lead (for
models without power cord with plug).
•
If the water-heater will not be used for a longer period
of time (more than 3 days) and the temperature in the
premise could drop below 0°C, the water in the water-
heater must be drained (observe the procedure outlined
in subsection 2 "Water heater's piping connection" of
s. IV), to avoid any possible damage of the appliance.
•
During the heating the appliance could produce a
hissing noise (the boiling water). This is common and
does not indicate any damage. The noise gets higher
with the time and the reason for this is the accumulation
of limestone. To remove the noise the appliance must
be cleaned from limestone. This type of cleaning is not
covered by the warranty.
•
In order to secure the water heater's safe operation,
the safety return-valve must undergo regular cleaning
and inspections for normal functioning /the valve
must not be obstructed/, and for the regions with
highly calcareous water it must be cleaned from the
accumulated lime scale. This service is not provided
under warranty maintenance.
•
All alterations and modifications to the water heater's
construction and electrical circuitry are forbidden. If
such alterations or modifications are established
during inspection, the appliance's warranty shall
be null and void. КAlterations and modifications
shall mean each instances of removal of elements
incorporated by the manufacturer, building in additional
components into the water heater, replacement of
elements by similar elements unapproved by the
manufacturer.
•
If the supply cord (of models that have one) is
damaged, it must be replaced by a representative of the
service or by an appropriately qualified person, in order
to avoid any risks
•
This appliance can be used by children aged from
8 years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience
and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe way
and understand the hazards involved
•
Children shall not play with the appliance.
•
Cleaning and user maintenance shall not be made by
children without supervision.
Instructions for use and maintenance
EN
7