Setting Up The Module In Ip_Axes - Fermax 5282 Manual De Instalador

Cod. 97847 V06_17

SETTING UP THE MODULE IN IP_AXES

To configure your IP_AXES software, you will need the module identifier. This is printed on a sticker
on the housing (e.g. ID: 00001). Make a note of this number.
Click on the "Technical" button and then "Site configuration".
Under the unit your module is connected to, click on "Extension modules" and then "Add a module
IP_AXES I/O".
The following window will then be displayed:
3200292
Enter the identifier of your module.
Configure degraded mode operation
(loss of connection between the mod-
ule and the unit).
You can also rename each input and
configure their mode (2- or 4-state).
You can also rename each output
("Sorties" (Outputs) tab).
Page 14/23