Assembly; Transport; Assembly On The Workbench - Zipper Maschinen ZI-KS210 Manual De Instrucciones

13

ASSEMBLY

Please check the product contents immediately after receipt for any eventual transport damage or
missing parts. Claims from transport damage or missing parts must be placed immediately after initial
machine receipt and unpacking before putting the machine into operation. Please understand that later
claims cannot be accepted anymore.
13.1 Assembly
Dust bag:
Pull the dust bag over the dust collector plug
Extension bracket:
Insert the extension bracket bars into the holes.
Thread one secure screw into the end of an
extension bracket bar.
Work piece downholder:
Place it in one of the mounting holes.

13.2 Transport

Only lift the mitre saw if the sawing arm is locked in its lowered position, the saw is switched off and
the mains plug has been pulled.
The saw may only be lifted using the external cast parts. Do not hold the saw by the safety cover or
operating handle to lift it.

13.3 Assembly on the workbench

 There are holes on the foot of the saw to make it easy to install it on a workbench.
 Secure the saw on a straight, flat workbench. Insert suitable screws (not supplied) through the
installation holes in the foot of the saw for this purpose.
 Furthermore you can attach the machine to miter saw stands.
NOTE:
If necessary you can also secure the saw to a piece of plywood with a minimum thickness of 13 mm.
The plywood may be secured on a working area using clamps or transported to another workplace and
secured there.
CAUTION:
The fastening surface must be flat. An uneven surface may result in the saw blade jamming or
imprecise cutting.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-KS210
ASSEMBLY
27