Cleaning And Care - Electrolux EEA150 Instrucciones De Uso

822 949 402_EEA150.book Seite 32 Freitag, 18. Januar 2008 7:44 19
g
Creating steam/frothing milk
(Figures 10, 11)
The hot steam can be used to froth
milk for a cappuccino or to heat
liquids.
1. Switch on the appliance.
0 Place the attachment provided onto
the steam nozzle (figure 10).
0 Switch on the appliance using the on/
off switch (figure 1/A). Wait until the
appliance has attained its operating
temperature and the orange
temperature indicator has gone out
(figure 1/D).
0 Switch the water/steam selection
switch (figure 1/B) to the symbol
2. Creating steam/frothing milk
0 Pour some milk or other liquid to be
heated into a heat-proof container.
0 Immerse the steam nozzle into the milk
or liquid to be heated (figure 11).
0 Turn the selector dial (figure 1/G) to
the left onto the
appliance will now begin to create
steam. At the beginning some drops of
water may drip out of the nozzle as
well.
Important: So as not to prevent the
steam from exiting, the steam nozzle
must not touch the base of the
container.
0 Stop steam from being emitted by
turning the selector dial (figure 1/G)
back to the right into the "•" position.
0 Place the steamed liquid to one side
and turn the steam selection switch
back to the
seconds. This will remove any milk
residue or residue from other liquids
out of the nozzle. Caution: The steam
is hot.
3 To achieve a fine, creamy milk froth it
is best to use cool low-fat milk.
32
.

Cleaning and care

symbol. The
symbol for a couple of
Making a cappuccino
Fill a large coffee cup from ½ to ¾ full
of espresso. Pour the frothed milk over
the top. Sprinkle a little cocoa over the
milk froth.
3. Heating water
0 Turn the water/steam selection switch
(figure 1/B) to the
0 Place a container under the steam
nozzle (figure 1/H).
0 Turn the selector dial for coffee, steam
and hot water (figure 1/G) to the
position. Hot water will be emitted
from the steam nozzle.
0 After the desired amount of hot water
has been obtained, turn the selector
dial for coffee, steam and hot water
(figure 1/G) to the "•" position.
Daily care
We recommend that, each day prior to
the first and after the last espresso, you
rinse out the system for approx. 10
seconds without espresso grounds in
order to prevent particles coffee from
becoming lodged in the appliance.
Proceed as for making an espresso, but
without using espresso grounds.
0 Afterwards, turn the selector dial
(figure 1/G) briefly to the
0 Pour any remaining water out of the
water tank.
Cleaning
(figures12,13,14,15,16)
1 Prior to cleaning the appliance, switch
it off and disconnect the power plug.
Do not clean any part of the
appliance in the dishwasher.
0 Wipe all the appliance's surfaces using
a damp cloth. Do not use harsh or
scratching cleaning agent.
0 Rinse out the water tank at least once
a week in normal rinse water.
position.
position.