Fermax 3267 Manual De Instalador página 31

5. From a street panel, make a call to the fi rst address in the range. The last address should
be greater than the fi rst one. All leds should be off.
Notice:
- To confi gure the fi rst and last addresses in the range to make the call from a push-button
panel, press the corresponding buttons for these addresses as indicated in steps 4 and 5.
Remember on a keypad panel, the call is made by entering the residence number + the
bell key.
Steps to DELETE the entered range.
1. Press the PRG button twice, the D led should light up.
2. Simultaneously press the Sec/Single and Min/All buttons. All leds should be off. The range
entered has been deleted.
Third step: Confi guration of the activation time.
To confi gure the activation time, follow point: 2.2 ACTIVATION TIME CONFIGURATION VIA
THE INTEGRATED BUTTONS (SEC/SINGLE - MIN/ALL)
2.5.2.2 ACTIVATION OF THE RELAY UPON RECEIVING A CALL TO RESIDENCE
COMMAND FROM A STREET PANEL.
Function description.
You can confi gure the relay to activate upon receiving a call to residence command from
a panel.
The panel, upon making a call, sends a call to residence command to the residence's ter-
minal (or terminals). The relay, if confi gured this way, can activate upon receiving the call
residence command. The residence terminals can receive the call to residence command
from a specifi c panel or from all panels in the installation, understanding that this command
is sent individually to each terminal.
- The call to residence command, relative to the residence terminals receiving them can
be confi gured as:
* All installed terminals (ALL).
* Terminals from a list (maximum 100 terminals).
* Terminals included within a defi ned range (consecutive).
- The call to residence command, relative to the panels sending them can be confi gured as:
* All panels (they individually send each command, not all in the group).
For example: In the installation the panels are P1, P2, P3, P4 and P5. The residence
terminal can receive a call from Panel P1 or Panel P2 or Panel P3 or Panel P4 or
Panel P5. Upon confi guring the call to residence command in All panels, the relay
is activated when the call to residence command is sent from any panel.
* Only one panel.
For example: In the installation the panels are P1, P2, P3, P4 and P5. The residence
terminal can receive a call from Panel P1 or Panel P2 or Panel P3 or Panel P4 or
Panel P5. Upon confi guring the call to residence command in a single panel, for
example, Panel P4, only when Panel P4 sends the call to residence command is the
relay activated.
Page 13