Peg-Perego pliko p3 compact Instrucciones De Uso página 18

_ Before use check that the peg-pérego ganciomatic
products are correctly fixed to the item.
_
WARNING Never leave your child unattended.
_ Always use the 5-point harness and attach the waist
strap to the leg divider strap.
_ WARNING This product is not suitable for running or
skating
_ Before use check that all the attachment mechanisms
are correctly engaged.
_ To avoid injury ensure that your child is kept away
when unfolding and folding this product.
_ Do not let your child play with this product.
INSTRUCTIONS FOR USE
1• OPENING: before opening the chassis remove the two
safety caps from the hooks, otherwise it will be impossible
to open it correctly (Fig.a). To open the chassis, pull the
two levers on the handlebars upwards (Fig.b);
2• at the same time, lift the chassis and it will open
automatically (Fig.c). To make sure that the stroller is
correctly open, check the two side hooks (Fig.d).
If the straps are not fasten correctly, press onto the
seat (fig_e) until it clicks into place.
3• ASSEMBLING: to mount the front wheels, lower lever A
and slip wheel B on until it clicks into place.
4• To mount the rear wheels connected by the brake cable,
place them with the brake facing externally (fig_a).
WARNING: ensure the hooks have clicked into place, as
in figure b.
5• Finally, hook the central element of the brake cable
onto the chassis, ensuring it clicks into place, as in the
figure.
6• BASKET: to mount the basket, slip the loops over
the front hooks A and rear hooks B and C. The figure
shows the attached basket.
7• ADJUSTING THE HANDLEBARS: The height of the two
handlebars can be adjusted to 3 positions. For the higher
position, press the button while pulling the handlebars
upwards. To lower it, do the opposite .
8• BRAKE: to set the brakes on the stroller, lower the
levers on the rear wheels with your foot (Fig.a). To
release the brakes, lift the lever.
Always set the brakes when the stroller is not
moving.
SWIVEL WHEELS: to swivel the front wheels lower the
levers as shown in arrow 1 (Fig.b).
WHEELS IN STATIONARY POSITION: To make them
stationary, push the lever in the opposite direction, as
indicated by arrow 2.
9• HOOD: to mount the hood, fasten the attachments
which are situated on the sides of the hood onto
those on the chassis, pushing outwards until the hood
clicks into place (Fig.a); fasten it onto the inside of the
armrest (Fig.b),
10• and onto the backrest of the stroller (Fig.c). The hood
has a window enabling you to observe your child, a
large and practical pocket (Fig.d) and a cord which
games can be hung on (Fig.e).
To remove the hood: unhook the hood's side
attachments from the chassis by pulling inwards,
unbutton it from the inside of the armrest and from
the backrest of the stroller.
11• You can detach the back part of the fabric by
unzipping it and use the hood also as a sun canopy
(Fig.a). To reattach the back part of the fabric, close the
zipper (Fig.b).
12• By lowering the stroller backrest, the rear hood
extends and through the double zipper a window can
be created to allow more air to circulate and watch the
child when sleeping.
13• 5-POINT SAFETY HARNESS: to fasten, insert the two
buckles of the waist strap (with attached shoulder
straps, arrow a) into the leg divider strap until they
click into place (arrow b). To unfasten them, press the
button which is situated in the centre of the fastener
(arrow c) and pull the waist strap outwards (arrow d).
14• To tighten the waist strap, pull on both sides in the
direction of the arrow. To loosen it do the opposite.
15• To adjust the height of the safety harnesses, release
the two buckles on the rear of the backrest.
Pull the shoulder straps towards you (arrow a) until the
buckles are released and insert them in the backrest
loops (arrow b). Remove the shoulder straps from the
sack (arrow c) and insert them in the most appropriate
buckle (arrow d), then reattach the two buckles
behind the backrest (arrow e). The buckles are securely
attached when a click is heard (fig f).
16• ADJUSTING THE FOOTREST: the footrest can be
adjusted to three positions. To lower the footrest, pull
the two side levers downwards while lowering the
footrest. To lift the footrest, pull it upwards until it
clicks into place.
17• ADJUSTING THE BACKREST: the backrest reclines to
four different positions. To lower the backrest, lift the
handle while lowering the backrest, locking it in the
desired position. To raise it, pull the backrest upwards.
18• FRONT BAR: to fasten the front bar, slip both ends of
the front bar into the armrests until it clicks into place.
19• The front bar can be opened to one side only to allow
the child to get in and out of the stroller easier when
he or she is older. To open the front bar, press the
button under the armrest while pulling out the front
bar (Fig.a). To remove the front bar, press the two
buttons under the armrests while pulling out the front
bar (Fig.b).
20• When removing the front bumper, insert the plugs
provided to close the armrests of the chassis.
21• REAR LEDGE: the rear ledge helps the mother
overcome small bumps and can also be used to carry a
second child (fig_a).
LOADING SEQUENCE: to use the PLIKO P3 COMPACT
with two children (fig_b), first set the brakes on the
stroller, then place the smaller child in the seat and
fasten the safety harness (1). Hold the handlebars (2)
and have the second child stand on the ledge (3).
• Never leave your children unattended.
• Do not allow a child to stand on the rear ledge when
the stroller is empty.
22• FOLDING UP: before folding up PLIKO P3 COMPACT,
remove the Navetta XL or the PrimoViaggio car
seat. The stroller can be folded up using one hand
only: pull first one lever upwards and then the other,
until they click.
23• Hold the central handlebar and pull it upwards until
the stroller folds up (fig_a). Check the correct closure
of the chassis from the safety hook (fig_b).
When folded, the chassis will stand upright .
24• CARRYING: PLIKO P3 COMPACT can be conveniently
carried by the central handle (with the front wheels set
on stationary) (fig.a). It can also be carried by the side
handle (fig_b).
25• REMOVABLE LINING: To remove the lining from the
stroller:. unhook the sack attachments from the
armrests in the order indicated (fig_a);. unfasten the
sack button at the sides;. remove the sack from the
footrest;. slide the leg divider part of the strap from
under the seat (fig_b);
- 18 -