Operation With Detergent; Stopping Operation - Comet K 200 Classic Manual De Instrucciones

Tabla de contenido

Idiomas disponibles

• Press the spray gun lever (17) and wait for a continuous jet of water to come out;

• Move the master switch (1) to "0" position and connect the lance hose (14) to the spray gun (13),

tightening well.

• Make sure the nozzle holder head (15) is not in the detergent dispensing position (refer to

WITH DETERGENT"

• Start the high-pressure cleaner again moving the master switch (1) to position "1".

• Press the gun spray lever (17), making sure the spray of the nozzle is even and this is not dripping.

• If necessary, adjust the pressure by turning the knob (6). Turn clockwise to increase pressure,

anticlockwise to decrease it.

The detergents recommended by the Manufacturer are over 90% biodegradable.

For instructions on how to use them, refer to the indications on the label of the detergent pack.

• Move the master switch (1) to "0" position.

• In the case of suctioning from the high power cleaner's tank (40), remove the cap (39) and, being careful

not to spill any liquid (maximum capacity is 3.5 l/0.92 US gal), fill the tank with the solution wanted.

• To ensure thorough cleaning, the detergent tank (40) can be taken out after releasing it by turning the

device (41) anticlockwise.

• In the case of suctioning from an external tank (

the coupling (43) the connection (25) of the detergent suction hose (23) from external tank as shown

. 7 -

fig

rEfErEncE

which you have already prepared with the detergent solution wanted: in this case too, follow the

indications given for the dosage on detergent pack label.

• Operate on the nozzle holder head (15) as shown in

• Start the high-pressure cleaner again, moving the master switch (1) to position "1" and operate the

lever (17): suction and mixing occur automatically as the water flows through.

• Turn the knob of the detergent tank cap (39) until the quantity of product wanted is dispensed.

• To stop the supply of detergent and restore high-pressure operation, stop the high-pressure cleaner

moving the master switch (1) to "0" position and operate on the head (15) as shown in

• When, with working pressures higher than 20 bar/290 psi, you release the spray gun lever (17) the

high-pressure cleaner stops automatically thanks to the Total-Stop device. It starts operating again

when pressing the spray gun lever.

• Completely close the water supply tap (or remove the suction hose from the water tank).

• Empty the water from the high-pressure cleaner, allowing this to operate for a few seconds with the

spray gun lever (17) pressed.

• Move the master switch (1) to "0" position.

• Remove the plug from the power socket.

• Eliminate any residual pressure in the high-pressure hose, by keeping the spray gun lever (17) pressed

for a few seconds.

• Wait for the high-pressure cleaner to cool down.

• In the Classic model, re-wind the high-pressure hose (20) carefully, avoiding any folds.

• If your machine has a hose reel (5) release it by turning knob (27) anticlockwise; rewind the high-pressure

hose neatly, taking care not to get it twisted, turning the hose reel anticlockwise with the crank (26);

lock the device by turning the knob (27) clockwise.

• Rewind the power cable (28) carefully onto its support (10).

• Store the high-pressure cleaner in a dry and clean place, making sure not to damage the power cable

and the high-pressure hose.

. 5.

opEration

in fig

STANDARD OPERATION (HIGH PRESSURE)

paragraph).