Danfoss TP7000+RF Instrucciones Del Usuario página 10

Display preferences
GB
Temperature display (°C or °F)
Press and hold DAY & COPY (for 2-3 seconds)
until display changes.
Clock display (12 or 24 hr)
Press and hold NEXT & DAY (for 2-3 seconds)
until display change.
(AM or PM will appear in 12 hr mode)
Setting the Clock & Day
Press PROG to begin programming.
DAY - Press DAY until correct day is shown
(1=Monday, 2=Tuesday etc).
To change TIME
TIME - Press + and - to change time (press
and hold to change in 10 min increments).
To
change
DAY
Setting the OSC Period, if enabled (see pg.5)
This display will ONLY appear if the OSC function has
been enabled by your installer.
Use the + or - buttons to select the OSC
period. The choices are 0:30 (30 mins), 1:00 (1
hr), 1:30 and 2:00.
The recommended setting is 0:30. If set to 0:00
the function is disabled.
Accepting the preset programmes
If you are happy to use the preset programmes on page 8, you don't
need to do anything else. To accept these settings just close the front
cover and after 2 minutes the pre-settings will automatically be accepted.
9