Installation Information - DURAVIT St.Trop Instrucciones De Montaje

Important information
Regarding the mounting instructions
These mounting instructions come as part of the Duravit
steam shower and should be read carefully prior to
installation.
Explanation of the key words and symbols
DANGER! At high risk of fatal hazards or
serious injuries
WARNING! At medium risk of
serious injuries
CAUTION! At low risk of
slight injuries
ADVICE! In the case of potential damage to
property
Link to the Electrical Installation section
Link to the installation information in this
section
Inspection (e.g. for scratches)
Indication of the length of time (e.g. 10 minutes)
Inspect to check for leak tightness
Target group and qualification
The steam shower must only be installed by trained
plumbing engineers. The electrical installation may only
be carried out by qualified electricians.
NOTE!
Local installation regulations and any country-specific
standards must be observed at all times.
6
DD_M_St.Trop_ECK/14.07.8

Installation information

Please read the pre-installation data sheets prior to
the installation. These are available to download on the
Internet at www.duravit.com.
NOTE!
Australia/New Zealand. Taps, valves and shower
accessories do not have Watermark or Wels approval for
installation. Please replace with approved alternative
(not included)
18
Installing the door hinge (Diagram 18)
> Hinge the door on the right or the left depending
on the position of the installation.
> Attach the hinge without exerting force and use
the enclosed lubricant.
32
Connecting the installation box (Diagram 32)
A: shower head
B: limescale filter
C: cold water
D: hand held shower head
E: warm water
A
E
D
43
Positioning the shower tray (Diagram 43)
> Check the height of the shower tray (-2 mm) and
readjust if necessary.
54
NOTE! (Diagram 54)
> The hose is required for ventilation therefore, it is
essential to leave it connected and open.
B
C