Power On; Preparation For Centrifugation; Centrifugation (Running) - OHAUS Frontier FC5306 Manual De Instrucciones

TM
Frontier FC5306
2.3

Power On

1. With the power switch on the back of this machine OFF.
2. Connect the output end of the adapter to the power socket on the
back of the machine, and then plug the unit to a power source.
2.4

Preparation for Centrifugation

1. Open the transparent lid (see photo below) and properly add load
in a balanced manner (refer to section "3.2 use and maintenance").
2. Close the lid then press the power switch on the back of this
machine to ON (note: The rotor will not run as long as the lid is open).
2.5

Centrifugation (Running)

1． After the lid is closed and the machine switched on, the rotor will
automatically start running with its speed increasing to the rated
speed, and then it will run stably.
2. Open the lid when the requirement of centrifugation is met, the rotor
will immediately slow down to a complete stop.
3. It is unnecessary to turn off power if another centrifugation is
required.
4. Turn off and unplug the machine when all centrifugation work is
completed or when not in use.
EN-5
press down to
open the lid