Risco WatchOUT 312PR Instrucciones De Instalación página 16

4. Press
5. Repeat the process for the other BUS detectors.
Assigning the WatchOUT 312PIR to a Zone
1. From the main installer menu enter Zones: One by One option (Quick key [2][1])
2. Select the zone number that you want to assign the BUS detector.
Note:
If you defined a BUS Zone Expander select a zone number from the virtual zones (defined
by the BUS zone expander).
3. Define Partitions, Groups, Zone Type and Zone Sound.
4. In the Termination category select [5] Bus Zone followed by
following display appears:
Z:001 Z:001 LINK TO: LINK TO:
ID:01 ID:01 TYPE:OPR12 TYPE:OPR12
5. Select the BUS zone number to assign to the programmed zone. The type field will be
updated automatically when selecting the BUS zone.
6. Press
the following display appears:
Z:001 Z:001 RESPONSE: RESPONSE:
N/A-BUS ZONE N/A-BUS ZONE
7. Press
Configuring the WatchOUT 312PIR Parameters
1. To access the WatchOUT settings option press [2][0][3] from the main installer menu.
The following display appears:
B-ZONE PRMS: B-ZONE PRMS:
ZONE#=001 ZONE#=001
2. Select the zone that the BUS zone was assigned to and press
now program the WatchOUT parameters as follows:
Zones Miscellaneous: BUS Zone
Quick Keys Parameter
[2][0][3][zzz]
LEDS
[1]
Defines the LEDS operation mode
[2][0][3][zzz]
Off
[1][1]
Disables the LEDS operation
[2][0][3][zzz]
Red Only
[1][2]
Only the Red led will operate. This option is highly recommended to avoid
the possibility that the intruder will "Learn" the detector behavior.
[2][0][3][zzz]
3 LEDS
[1][3]
All 3 LEDs will operate
[2][0][3][zzz]
PIR Sensitivity
[2]
Defines the PIR sensitivity of the detector
[2][0][3][zz]
Sensitivity Options
[2][1]..[4]
16
/ to confirm.
/ . The loop response category is not applicable to a BUS zone and
/ , assign label and press
(M:ZZ) (M:ZZ)
WatchOUT PIR Installation Manual
/
/
Default
3 LEDS
Normal
. The
/ . You can