Operational Summary; Diopter Adjustment - Nikon Forestry Pro Manual De Instrucciones

Operational Summary

Caution—use of controls or adjustments or
En
performance of procedures other than those
De
specified herein may result in hazardous radiation
Fr
exposure
Es
1. Install a battery in the battery chamber. (See "Changing
Batteries")
It
2. Rubber eyepiece cup
Ru
Eyeglass wearer: Collapse the eyepiece cups.
No
Non-eyeglass wearer: Do not collapse the eyepiece cups.

3. Diopter adjustment

Se
Adjust diopter to obtain a clear image in the LCD.
Fi
First, rotate the diopter adjustment ring counterclockwise
until it comes to a complete stop. Next, turn on the power
Nl
to activate the LCD when you look through the Nikon Laser
Dk
Forestry Pro. Rotate the diopter adjustment ring clockwise
until the display comes into focus.
Ro
If the diopter is not adjusted to correspond to your
Pl
eyesight, you may not be able to clearly focus your subject.
4. Measuring
Hu
Note: See the chapter "External and Internal display" for external
Cz
LCD panel.
Note: Depressing and holding down the POWER button causes
all symbols to be displayed in the internal LCD panel. After
you remove your finger from the POWER button, the last-
used setting is displayed. (If you briefly press the POWER
button then remove your finger, the LCD panel may
display the last-used setting without displaying all of the
symbols. This is not a malfunction or other problem.)
Before measuring, be sure to confirm settings, such as unit,
measurement/display mode and priority mode.
◎
: See the relevant mode section in this manual for setting.
14
POWER
LCD is illuminated
Align the reticle
with the target
POWER
appears
or
Indication
remains
illuminated for
30 sec.
30 seconds pass without operation ＊
Power off: LCD indications disappear
◎
Set your desired modes
☆
For continuous distance
and angle measurement
(up to 20 seconds), keep
button depressed.
MODE
※
Results are converted
to the mode set and
displayed.