Setting Mode; Before First Use; The Salt Container - Zanussi ZDLN6531 Manual De Instrucciones

Ocultar thumbs Ver también para ZDLN6531:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

selected automatically after you activate the
appliance.
When the latest programme selection is disabled,
the default programme is ECO.

SETTING MODE

How to enter setting mode
You can enter setting mode before starting a
programme. You cannot enter setting mode while
the programme is running.
To enter setting mode, press and hold
simultaneously 30 min and ECO for about 3
seconds.
The lights related to 60 min, 90 min and
160 min are on.
The display shows the current value of the
first available setting.
How to navigate in setting mode
You can navigate in setting mode using programme
buttons.
A

BEFORE FIRST USE

1. Make sure that the current level of the
water softener agrees with the hardness
of the water supply. If not, adjust the level
of the water softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start the programme 30 min to remove any
residuals from the manufacturing process. Do
not use detergent and do not put dishes in the
baskets.
After starting the programme, the appliance
recharges the resin in the water softener for up to 5
minutes. The washing phase starts only after this
procedure is complete. The procedure is repeated
periodically.
12
B
C
A. Previous button
B. OK button
C. Next button
Use Previous and Next to switch between the
basic settings and to change their value.
Use OK to enter the selected setting and to
confirm changing its value.
How to change a setting
Make sure the appliance is in setting mode.
1. Use Previous or Next to select the desired
setting.
The display shows the current setting value (a digit
and the dedicated letter).
2. Press OK to enter the setting.
The current setting value flashes.
3. Press Previous or Next to change the value.
4. Press OK to confirm the setting.
The new setting is saved.
The appliance returns to the basic settings
list.
5. Press and hold simultaneously 30 min and
ECO for about 3 seconds to exit setting mode.
The appliance returns to the programme selection.
The saved settings remain valid until you change
them again.

THE SALT CONTAINER

CAUTION! Use rough salt designed
for dishwashers only. Fine salt
increases the risk of corrosion.
The salt is used to recharge the resin in the water
softener and to assure good washing results in
daily use.
How to fill the salt container
1. Turn the cap of the salt container
counterclockwise and remove it.
2. Put 1 litre of water in the salt container (only for
the first time).
3. Fill the salt container with 1 kg of salt (until it is
full).

Publicidad

Tabla de contenido
loading

Tabla de contenido