Before Use - miniland baby digimonitor 3.5 plus Manual De Instrucciones

ENGLISH
• Consult the Customer Care department.
To ensure compliance with the RED Directive 2014/53/
EU, this equipment has special shielded cables.
Operating with unapproved equipment or using
unshielded cables will probably cause interference to
radio or TV reception.
3.3. CHOOSING THE RIGHT PLACE
• Place the electronic device somewhere out of the
reach of children so as to avoid accidents.
• The baby unit must be situated at least 1 and 1.5
meters away from the baby's cot. Never place the
baby unit inside the cot, bed or playpen, nor secure
the tripod to them. Make sure that the unit, the cables
and the adapter are well out of the reach of the baby
and other young children.
• Put the baby monitor in a place where the air can
circulate freely. Do not place it on duvets or soft
blankets nor in the corners of cupboards, shelves etc.
• Place the baby monitor well away from heat sources
like radiators, chimneys, kitchens and direct sunlight.
• Keep the Camera away from TV appliances,
repeaters and radios. The intense radio signals
generated by these elements could cause noise
or even sounds or images to be broadcast on
the monitor. Should this occur, move the camera
somewhere else.
4. PRODUCT CHARACTERISTICS
4.1. MONITOR CONTROLS AND FUNCTIONS
(FIGURE 1)
MONITOR (FIGURE 1.1)
1. ON/pairing LED indicator
2. Microphone
3. Charge indicator
4. LCD Screen
5. ON/OFF button
6. Loudspeaker
7. Neck strap hook
8. Set button▲
9. Zoom/Menu/Back button
10. Set button ▼
11. OK/Scan
12. Baby talk button
13. AV output connector
14. Mini USB power/PC connector
15. Folding support
16. Battery compartment cover
17. Retractable antenna
DISPLAY
Screen Icons (FIGURE 1.2)
a. Signal level
b. Volume selected on the monitor
c. Night vision
d. Lullabies
e. VOX Mode
f. Selected camera
g. Night light
h. Transmission level
i. Battery level
j. Talk to the baby
k. Alert ON
Menu Icons (FIGURE 1.3)
A. Select/Add/Remove camera menu
B. Camera Settings Menu
C. VOX/Standby
D. Transmission level
E. Alert
F. Vibration
G. Screen configuration: luminosity
4.2. CAMERA CONTROLS AND FUNCTIONS
(FIGURE 2)
I. Retractable antenna
II. Photo sensor
III. Power button
IV. Hanging attachment
V. Speaker
VI. Link button
VII. Mini USB power connector
VIII. Microphone
IX. ON/link LED
X. Camera lens
XI. Infrared
XII. Tripod attachment
5. USAGE INSTRUCTIONS

5.1. BEFORE USE

5.1.1. PARENTS' UNIT POWER SUPPLY AND
BATTERY USAGE
The monitor, the parents' unit, of this baby monitor
is designed for use with the battery or with the AC/
DC adapter supplied. The rechargeable battery must
be charged for at least eight hours before using the
unit for the first time or if it has not been used for a
prolonged time period.
Your baby monitor comes with a rechargeable, 3.7V
1200mAh Li-ion battery for the monitor. We would
recommend using the battery in the monitor so as
to be able to receive the audio/video signal from the
camera anywhere. Connect the monitor to the adaptor
plugged into the mains whenever possible so as to
keep the battery charged.
BATTERY INSTALLATION (FIGURE 3)
1. Unscrew and remove the battery compartment
cover (16) situated at the rear of the unit.
2. Insert the Li-ion battery (supplied).
3. Put the battery cover back in its place and secure
it with the screw.
Precaution: Only
recommended type as otherwise there is a risk
of explosion. Dispose of worn out batteries
responsibly.
Note: When you don't use the two units, it is
recommended to turn them off in order to save
the battery.
CHARGING THE BATTERY
Insert the rechargeable battery in accordance with the
instructions stated in the previous section.
Connect the AC adapter connector to the mini-USB
socket situated on the side of the unit
(14). Only use the adapter supplied. Plug in the
adapter to the mains.
Whilst the monitor is connected to the mains and
charging, the charging indicator LED (3) will be lighted
in red.
21
use batteries of the