TRAPP TRC-40 Manual De Instrucciones página 37

www.trapp.com.br
Repairs should be made by authorized TRAPP
 
technicians only.
Preserve your equipment. Frequently check if
 
any component is damaged or check for any
other condition that may affect its optimum
operation. Shall any problem arise, fix it before
using the equipment. Many accidents are
caused by lack of proper maintenance.
Keep the blades sharp and clean.
 
The blades keeps moving after the equipment
 
is switched off. Therefore be aware of that
when servicing.
Additional Safety and Operation Instructions
Make sure the voltage of the power source is
 
the same of that of the equipment (TRC-40).
Carefully read instructions and get familiar
 
with the controls and proper used of the
equipment.
Remember that the operator or user is
 
responsible for any accident or damage
involving people or their properties.
Do not operate the equipment barefooted or
 
with sandals.
Always wear adequate shoes and pants,
 
goggles, gloves and ear plugs.
Avoid operating the equipment in humid
 
places.
Use the equipment in a well ligth environment.
 
Before feeding any kind of foliage, start the
 
motor and wait for it to reach maximum
revolution.
Do not introduce anything in the equipment
 
with the motor off.
Note: According to the Brazilian standard
NBR 5410, it is compulsory to install a device to
protect against residual differential current (DR
device) in the electrical installation. The function
of the "DR" is to protect the user against serious
electrical shock risk (consult an electrician).
5 - Service
Call qualified professionals to service
 
the equipment. Use original parts only.
Always call TRAPP Authorized Service
Technicians. TRAPP is not responsible
for occasional accidents caused by the use
of spare parts that are not original.
Do not use the equipment during periods of
 
power supply failure (TRC-40).
Whenever you perform any cleaning or
 
maintenance operations, first make sure that
the engine is turned off, that the blades are
stopped, and remove the TRC-40's power
extension from the power outlet and the
TRC-50's spark plug cable.
If the equipment starts to vibrate, unplug it.
 
Check the cause of the vibration as it indicates
that the equipment needs adjustment and
repair.
Check the status of the power supply cord.
 
Never fix it with insulating tape (TRC-40).
Never use a water jet to clean the equipment;
 
use a cloth soaked in neutral detergent. Water
inside the equipment can damage the electric
circuit of the motor, besides increasing the
risk of an electric shock.
37