TRAPP TRC-40 Manual De Instrucciones página 44

1
3
2
Image merely illustrative.
Replace the belts if dry, cracked or damaged. To
change them, proceed as follows:
Remove the hexagonal bolt (1), the lockwasher
 
(2) and the flat washer (3).
Remove the top side of the machine (4) to
 
have access to the belts (5) and so be able to
change the belt (5) when required.
To assemble the unit, 1 follow the assembly
 
sequence of the exploded drawing above.
Belt model: V A-41.
O 
To stretch the belt 6 proceed as follows:
Loosen the nuts (1) in front of the handles (2)
 
with the wrench 7/16" (5).
44
Belt Maintenance - TRC-50
4
3
7
6
5
Loosen the nut (3) opposite the handle (4)
 
with the wrench 9/16" (5).
After releasing the nuts (1 and 3) drop sticks
 
(2 and 4) and perform the adjustment of belt
tension by pressing the knob (4).
1
After adjusting the belt tension, perform
 
tightening the nut (3) with the wrench 9/16".
2
Place the nut (1) on the handle (2) and tighten
 
until it touches the body of the machine (6).
Perform tightening the nuts (1) with the
 
wrench 7/16" (5).
Note: A wrench with dimensions of 7/16" and 9/16" is
provided with the package instructions.
5
3
4
Image merely illustrative.
www.trapp.com.br
2
6
1