Other Functions; Locking The Remote Controller Buttons (Operation Function Limit Controller) - Mitsubishi Electric Mr.SLIM PKA-RP35HAL Manual De Instrucciones

7. Other Functions

7.1. Locking the Remote Controller Buttons (Opera-
tion function limit controller)
■ If you wish, you can lock the remote controller buttons. You can use
the Function Selection of remote controller to select which type of lock
to use.
(For information about selecting the lock type, see section 8, item [2]
(1)). Specifically, you can use either of the following 2 lock types.
Lock All Buttons:
Locks all of the buttons on the remote controller.
Lock All Except ON/OFF:
Locks all buttons other than the ON/OFF button.
Note:
The "Locked" indicator appears on the screen to indicate that buttons are
currently locked.
TIME SUN
˚C
TEMP.
7.2. Error Codes indication
If you have entered contact number to be called in the event of a problem, the screen displays this number.
(You can set this up under Function Selection of remote controller. For information, refer to section 8.)
●
If the ON lamp and error code are both blinking: This means that the air conditioner is out of order and operation has been stopped (and cannot re-
sume). Take note of the indicated unit number and error code, then switch off the power to the air conditioner and call your dealer or servicer.
ERROR CODE
˚C
˚C
Error Code
●
If only the error code is blinking (while the ON lamp remains lit): Operation is continuing, but there may be a problem with the system. In this case,
you should note down the error code and then call your dealer or servicer for advice.
* If you have entered contact number to be called in the event of a problem, push the Check button to display it on the screen. (You can set this up
under Function Selection of remote controller. For information, refer to section 8.)
12
Lock Indicator
FUNCTION
˚C
ON/OFF
CLEAR
When the Check button is pressed:
CALL:XXXX
XXX:XXX
ON/OFF
<How to Lock the Buttons>
1. While holding down the Filter button
OFF button for 2 seconds. The "Locked" indication appears on the
screen (at ), indicating that the lock is now engaged.
* If locking has been disabled in Function Selection of remote control-
ler, the screen will display the "Not Available" message when you
press the buttons as described above.
˚C
• If you press a locked button, the "Locked" indication (at
on the display.
˚C
<How to Unlock the Buttons>
1. While holding down the Filter button
OFF button for 2 seconds—so that the "Locked" indication disap-
pears from the screen (at ).
˚C
ERROR CODE
Error Code
Indoor Unit's Refriger-
ant Address
Alternating Display
p
ON/OFF
, press and hold down the ON/
FUNCTION
˚C
) will blink
FUNCTION
˚C
, press and hold down the ON/
˚C
ON lamp
(Blinking)
ON/OFF
Indoor Unit No.