Emergency Operation For Wireless Remote-Controller; Care And Cleaning - Mitsubishi Electric Mr.SLIM PKA-RP35HAL Manual De Instrucciones

9. Emergency Operation for Wireless Remote-controller

Fig. 9-1
(For PKA-RP·HAL) P·HAL)
Fig. 9-2
When the remote controller cannot be used
When the batteries of the remote controller run out or the remote control-
ler malfunctions, the emergency operation can be done using the emer-
gency buttons.
[Fig.9-1] DEFROST/STAND BY lamp
Operation lamp
Emergency operation switch (heating)
Emergency operation switch (cooling)
Receiver

10. Care and Cleaning

C
TEMP.
■
Indicates that the filter needs cleaning.
Clean the filter.
■
When resetting "FILTER" display
When the [FILTER] button is pressed 2 times successively after
cleaning the filter, the display goes off and is reset.
Note:
●
When 2 or more different types of indoor unit are controlled, the cleaning
period differs with the type of filter. When the master unit cleaning period
arrives, "FILTER" is displayed. When the filter display goes off, the cumu-
lative time is reset.
●
"FILTER" indicates the cleaning period when the air conditioner was used
under general indoor air conditions by criteria time. Since the degree of
dirtiness depends on the environmental conditions, clean the filter accord-
ingly.
●
The filter cleaning period cumulative time differs with the model.
●
This indication is not available for wireless remote controller.
►
Cleaning the filters
• Clean the filters using a vacuum cleaner. If you do not have a vacuum clean-
er, tap the filters against a solid object to knock off dirt and dust.
• If the filters are especially dirty, wash them in lukewarm water. Take care to
rinse off any detergent thoroughly and allow the filters to dry completely
before putting them back into the unit.
Caution:
• Do not dry the filters in direct sunlight or by using a heat source, such as an
electric heater: this may warp them.
• Do not wash the filters in hot water (above 50°C), as this may warp them.
• Make sure that the air filters are always installed. Operating the unit without
air filters can cause malfunction.
Caution:
• Before you start cleaning, stop operation and turn OFF the power supply.
• Indoor units are equipped with filters to remove the dust of sucked-in air.
Clean the filters using the methods shown in the following sketches.
E.O.
SW
C
FILTER
ON/OFF
Starting operation
• To operate the cooling mode, press the
seconds.
• To operate the heating mode, press the
seconds.
Stopping operation
• To stop operation, press the
than 2 seconds.
[Fig.9-2] DEFROST/STAND BY lamp (Orange)
Operation lamp (Green)
Emergency operation switch (cooling/heating)
Receiver
• Each press of the emergency operation switch will toggle the operation
mode.
• Check "COOL/HEAT" with the operation monitor display. (The orange
lamp follows this monitor display for 5 seconds after pressing the
emergency operation switch.)
[Heat pump type]
Cooling Heating
Operation Monitor Display
GREEN ORANGE
○ ○
The orange lamp follows the
STOP
switch operation as indicated
● ○
COOL at the left for 5 seconds, and
● ● then it will return to the normal
HEAT
display.
○ ●
Turning off Lighting
: :
Note:
• Details of emergency mode are as shown below.
Operation mode
Set temperature
Fan speed
Airflow direction Horizontal
Filter removal
Caution:
• In removing the filter, precautions must be taken to protect your
eyes from dust. Also, if you have to climb up on a stool to do the
job, be careful not to fall.
• When the filter is removed, do not touch the metallic parts inside
the indoor unit, otherwise injury may result.
PKA-RP·HAL
Pull both the bottom corners of the intake grille to open the grille, then lift the
filter.
button for more than 2
button for more than 2
button or the button for more
[Cooling only type]
Cooling
Stop
COOL HEAT
24°C 24°C
High High
Downward 4 (5)
Stop
17