Using The Minibar; Using The Temperature Setting Function - Dometic DM 50NTE Instrucciones De Montaje

DM50NTE
• Clean dust and dirt from the condenser at regular intervals.
7.2

Using the minibar

The minibar starts cooling when connected to power. During normal operation the
Power Status LED is glowing. If an error occurs the Error LED is blinking (see chapter
"Troubleshooting" on page 21).
7.3

Using the temperature setting function

To avoid food waste, note the following:
• Keep temperature fluctuation as low as possible. Only open the minibar as often
and for as long as necessary. Store the foodstuff in such a way that the air can still
circulate well.
• The minibar is equipped with an automatic temperature regulation function.
Select the average of the possible temperature values.
• Adjust the temperature to the quantity and type of the foodstuff.
The minibar is set by default to a cooling temperature of 7 °C (44.6 °F) at an ambient
temperature of 25 °C (77 °F).
You can use the setting button (fig. 4 4, page 4) to set the cooling temperature to
one of three values (5 °C, 12 °C and 7 °C (41 °F, 53.6 °F and 44.6 °F)).
Thereby the temperature will be changed in the order 5 °C ... 12 °C ... 7 °C ... 5 °C
(41 °F ... 53.6 °F ... 44.6 °F ... 41 °F) etc.
➤ Press the setting button (fig. 4 4, page 4) and keep it pressed for 5 s, until the
internal lamp (fig. 4 1, page 4) starts to blink.
➤ Press immediately the setting button (fig. 4 4, page 4) again.
✔ The internal lamp (fig. 4 1, page 4) indicates the setting temperature:
– 5 °C (41 °F): the lamp flashes five times in three intervals
– 12 °C (53.6 °F): the lamp flashes once in three intervals
– 7 °C (44.6 °F): the lamp flashes three times in three intervals
I
NOTE
The minibar sets the cooling temperature automatically to 7 °C
(44.6 °F), when it is connected to a power source.
EN
Operation
21