Operation - Lacor MAXI 110 W Instrucciones De Uso

MAKE A BAG
1.- Connect the power cable to a 220-240v/50Hz outlet.
2.- Tighten the Open/Close Button simultaneously and open the Cap.
3.- Move the Cutting Bar up and extend the roll until reaching the desired bag dimensions.
4.- Move the Cutting Blade to one side, lower the Cutting Bar and move the Blade from one side
to the other.
5.- Put one side of the bag above the Sealing Pad and close the Cap until you hear a "click" on
each side, which indicates that the Cap has correctly closed.
6.- Press the "SEAL" Button and an LED light will turn on. Once it is turned off, the seal will be
ready and the bag will be ready for putting food inside.
NOTE: During continuous use of the sealing function, the bar may overheat and make
holes in the bag, which produces an incorrect seal. Let it cool before using it again.
VACUUM + SEAL FUNCTION
1.- Clean the Sealing Pad in order to eliminate the remains and impurities.
2.- Insert the food inside the bag and place the side of the bag inside the Bell Vacuum.
NOTE: Never cover the Air Intake.
3.- Close the Cap until you hear a "click" on each side, which indicates that the Cap has closed
correctly.
4.- Press the Pressure Button in order to select the type of pressure:
A.- Normal (normal): The bag will reach a 0,6 bar level of pressure.
B.- Gentle (soft): The bag will reach a 0,8 bar level of pressure.
NOTE: Vacuuming at a higher pressure will guarantee a greater storage time.
5.- Press the "Vacuum & Seal" Button and the vacuuming process will start. The LED lights on the
Control Panel will show the process of the work.
NOTE: If during the vacuuming process it is determined that the pressure is sufficient,
press the "Seal" button in order to seal the bag.
6.- Use the "Cancel" button to stop the process whenever you want.
7.- Once the process has finished, press the Open Cap/Close Cap Button to remove the bag..
CANISTER FUNCTION
NOTE: The accessories for performing this function are not included with the packaging.
Only use this function to vacuum canisters.
1.- Open the Cap and insert the connector from the pneumatic tube into the Air Intake that is
located in the Bell Vacuum
2.- Connect the other side to the orifice on the Cap of the Canister.
3.- Be sure that the LED Pressure Light is in the "Normal" state and press the "Canister" Button.
The pump will begin to suction air out from inside the Canister.
4.- The process will finish when the air inside the Canister has been completely suctioned out.

OPERATION

33