Replacing The Ribbon; Cleaning; Disposal; Malfunctions - Mettler Toledo RS-P42 Instrucciones De Manejo

5.2

Replacing the ribbon

3 1
4
2
6
5
5.3

Cleaning

As the printer housing is made of top grade, resistant materials, all commercially available clean-
ing agents may be used.
5.4

Disposal

6

Malfunctions

Malfunction / Message
Printout unreadable
Green pilot lamp
does not light up
• Pull paper out of printing unit (1).
• Remove ribbon cover (2, 3, 4).
• To remove ribbon cartridge, press in direction of arrow (5).
• Insert new ribbon and if need be, take up slack with tension-
ing wheel (6).
• Refit ribbon cover.
• Insert paper and feed through slit in the printing unit as far as
it will go.
• Press and hold
In conformance with the European Directive 2002/96/EC on
Waste Electrical and Electronic Equipment (WEEE) this device
may not be disposed of in domestic waste. This also applies to
countries outside the EU, per their specific requirements.
Please dispose of this product in accordance with local regula-
tions at the collecting point specified for electrical and electronic
equipment. If you have any questions, please contact the re-
sponsible authority or the distributor from which you purchased
this device.
Should this device be passed on to other parties (for private or
professional use), the content of this regulation must also be
related.
Thank you for your contribution to environmental protection.
Possible cause
• Ribbon worn / entangled
• Service life of printing unit at an end • Please contact
• Printer on
• No power, fuse defective
until sufficient paper has been fed in.
Rectification
• Change / tension ribbon
METTLER TOLEDO service
• Please contact
METTLER TOLEDO service
RS-P42 Printer 7