Trouble Shooting - Johnson SECADORA JSC8AA Manual De Usuario

MAINTENANCE
Note!
• The fluff accumulated on the filter will block the air circulation, which will cause the
extension of drying time and energy consumption.
• Do disconnect the power cord before cleaning!
• Do not operate the dryer without the filter!
• Clean the filter after each use to prevent lint accumulation inside the dryer.
Clean heat exchanger
• As necessary, approx. once every 2 months,
remove the fluff from the heat exchanger
using the sponge or soft brush.
• When doing this, please use gloves.
Note!
• TThe fluff can be removed more easily if it is
first dampened.
V.1
19
MAINTENANCE

Trouble Shooting

Dispiay
Reason
Humidity sensor error
" E32 "
Temperature sensor error
" E33 "
！ Warning!
• Only authorised technicans can carry out repairs.
• Before you call service, please check if you have dealt with the
fault yourself or if you have followed the user instructions.
Problem
• Check if the power supply works.
•Display does not on
• Check if the mains plug is inserted.
• Check the selected programme .
• Press the 【On/Off】button.
• Empty water container.
• " "or "FUL" is lighting
• If the light is still on, please call the service.
• Clean heat exchanger.
•" "is light ing
• Clear lint filter.
• Check the
• Check the programme has set.
•Dryer does not start
• Check the start button has selected.
• Clean lint filter and
• Empty container.
•Degree of dryness was not
• Check drain hose.
reached or drying time too
• Dryer installation place is too restricted.
long
• Clean the moisture sensors.
• Keep the Air inlet clean.
• Use higher drying intensity level programme or
time programme.
！ Warning!
If you cannot deal with the fault by yourself and need help:
• Press the 【On/Off】button.
• Pull out the mains plug and call the service.
Solutions
Please contact your local
service center if the
problem persists.
Solution
the door has closed.
heat exchanger .
V.1
20